Enabling The Rmon Statistics Function On The Interface - Huawei Quidway S5700 Series Configuration Manual - Network Management

Quidway S5700 Series Ethernet Switches
Configuration Guide - Network Management
Pre-configuration Tasks
Before configuring RMON, complete the following tasks:
l
l
Data Preparation
To configure RMON, you need the following data.
No.
1
2
3
4
5
6

7.3.2 Enabling the RMON Statistics Function on the Interface

You need to enable traffic statistics function on the interface where traffic statistics are collected.
If the traffic statistics function is not enabled on the interface, statistics values of in both
ethernetStatsTable and HistoryControlTable are 0.
Context
Do as follows on the switch on which traffic statistics should be collected:
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
interface { gigabitethernet | xgigabitethernet } interface-number
The interface view is displayed.
Step 3 Run:
rmon-statistics enable
The RMON statistics function is enabled on the interface.
If the statistics function is not enabled on the interface, the statistics value in ethernetStatsTable
and historyControlTable of RMON is 0.
----End
Issue 01 (2011-10-26)
Configuring parameters for Ethernet interfaces
Configuring basic SNMP functions
Data
Interface on which the statistics function is enabled
Statistics table to be used and related parameters
HistoryControl table to be used and related parameters
Event table to be used and related parameters
Alarm table to be used and related parameters
Prialarm table to be used and related parameters
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
7 RMON Configuration
394