Example For Configuring Flexible Netstream Traffic Statistics - Huawei S9700 Series Configuration Manual

S9700 Core Routing Switch
Configuration Guide - SPU
import-route ospf 1
peer 10.3.1.1 enable
#
return

5.8.3 Example for Configuring Flexible NetStream Traffic Statistics

Networking Requirements
As shown in
Switch A. The Flexible NetStream feature is enabled on GE1/0/0 of Switch B. Then you can
collect statistics on the inbound and outbound traffic on an interface based on the destination IP
address aggregation and destination port aggregation. The statistics can be sent to the NSC.
Figure 5-4 Networking diagram for Flexible NetStream
Configuration Roadmap
The configuration roadmap is as follows:
1.
2.
3.
4.
Data Preparation
To complete the configuration, you need the following data:
l
l
l
l
Issue 01 (2012-03-15)
Figure 5-4, the enterprise network is connected to Switch B of the carrier through
User
GE1/0/0
Network
VLANIF 100
10.1.1.1/24
SwitchA
Set IP addresses for interfaces on Switch A and Switch B.
Mirror the traffic on GE 1/0/0 of Switch B to the SPU.
Enable the Flexible NetStream feature on the SPU.
Enable the Flexible NetStream feature on GE1/0/0 of Switch B.
IP address of each interface
Version of the exported packets
Address and port number of the NSC and source address contained in the packets
Traffic statistics to be sent to the NSC
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
GE2/0/0
VLANIF 200
10.2.1.1/24
NSC&NDA
10.2.1.2/24
GE1/0/0
VLANIF 100
10.1.1.2/24
XGE4/0/0
XGE4/0/1
VLANIF101
22.22.22.2/24
5 NetStream Configuration
SwitchB
XGE0/0/1
VLAN101
XGE0/0/2.2
22.22.22.1/24
176