Configuring Ip Source Trail; Establishing The Configuration Task; Configuring Ip Source Trail Based On The Destination Ip Address - Huawei Quidway S9300 Configuration Manual

Quidway S9300 Terabit Routing Switch
Configuration Guide - Security

6.3 Configuring IP Source Trail

This section describes how to configure IP source trail.

6.3.1 Establishing the Configuration Task

6.3.2 Configuring IP Source Trail Based on the Destination IP Address

6.3.3 Checking the Configuration
6.3.1 Establishing the Configuration Task
Applicable Environment
When a user host is under attack, you can configure IP source trail on the S9300 connected to
the host to trace the attack source and take defense measures after confirming the attack source.
Pre-configuration Tasks
Before configuring IP source trail, complete the following task:
l
Data Preparation
To configure IP source trail, you need the following data.
No.
1
6.3.2 Configuring IP Source Trail Based on the Destination IP
Address
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
ip source-trail ip-address ip-address
IP source trail based on the destination IP address is configured.
----End
Issue 01 (2009-07-28)
Setting parameters of the link layer protocol and IP addresses for the interfaces to ensure
that the link layer protocol is in Up state on the interfaces
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
6 IP Source Trail Configuration
Data
Destination IP address of the attacked user
host
6-3