Example For Configuring The Tcp Test - Huawei Quidway S5700 Series Configuration Manual - Network Management

Quidway S5700 Series Ethernet Switches
Configuration Guide - Network Management

6.27.8 Example for Configuring the TCP Test

Networking Requirements
As shown in
TCP connection between Switch A and Switch B.
Figure 6-10 Networking diagram for configuring the TCP test
SwitchA
Configuration Roadmap
The configuration roadmap is as follows:
1.
2.
Data Preparation
To complete the configuration, you need the following data:
l
l
Procedure
Step 1 Configure reachable routes between Switch A and Switch B, between Switch A and Switch C,
and between Switch B and Switch C. The configuration details are not mentioned here.
Step 2 Configure the NQA server on Switch C.
# Configure the IP address and port number used to monitor TCP connections on the NQA server.
<SwitchC> system-view
[SwitchC] nqa-server tcpconnect 10.2.1.2 9000
Issue 01 (2011-10-26)
#
interface GigabitEthernet0/0/1
port hybrid pvid vlan 110
port hybrid untagged vlan 110
#
ip route-static 10.1.1.0 255.255.255.0 10.2.1.1
#
snmp-agent
snmp-agent local-engineid 000007DB7F00000100006294
snmp-agent sys-info version v3
#
return
Figure 6-10, the NQA TCP Private test is used to obtain the time for setting up a
GE0/0/1 GE0/0/1
VLANIF100 VLANIF100
10.1.1.1/24 10.1.1.2/24
Configure Switch A as the NQA client and configure Switch C as the NQA server.
Configure the monitoring port number on the NQA server and create an NQA TCP test on
the NQA client.
Host address of the server
Port number used to monitor the TCP service on the server
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
SwitchB
GE0/0/2
VLANIF110 VLANIF110
10.2.1.1/24 10.2.1.2/24
6 NQA Configuration
SwitchC
GE0/0/1
NQA Server
349