Rep 7.3 Bypass Pickup Roll Rubber; Rep 7.4 Tray 2 Feed Motor And Pickup Solenoid - Xerox Phaser 3635MFP Service Manual

REP 7.3 Bypass Pickup Roll Rubber

Parts List on PL 7.10
Removal
WARNING
Switch off the electricity to the machine. Disconnect the power cord from the customer
supply while performing tasks that do not need electricity. Electricity can cause death or
injury. Moving parts can cause injury.
Before performing this procedure, refer to
1. Open the front cover assembly, PL 28.10 Item
2. Remove the bypass pickup roll, refer to
a. Release the tab, then slide the locking collar to the left.
b. Move the pickup roll and the left idler to the left.
c. Rotate the pickup roll through 90 degrees to remove it from the shaft.
Locking collar
Left idler
Pickup roll
Figure 1 Pickup roll removal
3. Separate the bypass pickup roll, then remove the pickup rubber,
Replacement
1. Replacement is the reverse of the removal procedure.
Repairs and Adjustments
REP 7.3, REP 7.4
CAUTION
GP 10 General Disassembly Precautions.
7.
Figure 1. Perform the following:
PL 7.10 Item

REP 7.4 Tray 2 Feed Motor and Pickup Solenoid

Parts List on PL 8.17
Removal
Switch off the electricity to the machine. Disconnect the power cord from the customer
supply while performing tasks that do not need electricity. Electricity can cause death or
injury. Moving parts can cause injury.
Take care during this procedure. Sharp edges may be present that can cause injury.
Before performing this procedure, refer to
1. Remove the tray 2 module,
2. Remove 3 screws to release the tray 2 left cover,
Take care when releasing the tabs at the corners, they may be susceptible to breaking.
3. Use a flat bladed screwdriver to release the tabs underneath and then lift the panel off the
pegs at the top.
4. Remove the drive assembly bracket,
5. Remove the tray 2 feed motor,
as required.
Replacement
Ensure all ground leads are connected.
1. Replacement is the reverse of the removal procedure.
NOTE: When reinstalling the side panel, stand the tray on the rear panel and engage the
lower tabs before snapping the top edge over the pegs.
26.
April 2010
4-22
WARNING
WARNING
CAUTION
GP 10 General Disassembly Precautions.
PL 8.15 Item 28.
PL 8.15 Item 5.
CAUTION
PL 8.15 Item 20.
PL 8.15 Item 23 or tray 2 pickup solenoid,
WARNING
Phaser 3635MFP/WorkCentre 3550
PL 8.17 Item 24