Rep 56.6.2 Dadf Feed Motor - Xerox WorkCentre 5021 Service Documentation

Figure 8 j0lj45625
Replacement
1. To install, carry out the removal steps in reverse order.
Repairs and Adjustments
REP 56.6.1, REP 56.6.2

REP 56.6.2 DADF Feed Motor

Parts List on PL 56.6
Removal
When turning OFF the power switch, check that the 'Data' lamp is OFF and that there is
no Job in progress.
Turn OFF the power switch and make sure that the screen display turns OFF.
Check that the power switch is OFF and unplug the power plug.
1. Remove the DADF Front Cover.
2. Remove the DADF Rear Cover.
3. Remove the Document Tray.
4. Remove the Harness Guide and the wire harness.
5. Remove the DADF Feed Motor. (Figure 1)
(1) Remove the screw (x3).
(2) Remove the DADF Feed Motor.
Replacement
1. To install, carry out the removal steps in reverse order.
2. When installing the DADF Feed Motor, align the Tab (x2) of the DADF Feed Motor
Bracket to the Cutout (x2) of the DADF Feed Clutch and DADF Takeaway Clutch. (Figure
2)
08/2012
4-74
WARNING
(REP 56.2.1)
(REP 56.2.2)
(REP 56.9.1)
(REP 56.6.1)
Figure 1 j0lj45628
WorkCentre 5021/5019
Initial Issue