Register Descriptions; Standby Control Register (Sbycr) - Hitachi H8S/2378, H8S/2378R Series Hardware Manual

22.1

Register Descriptions

The registers relating to the power-down mode are shown below. For details on the system clock
control register (SCKCR), refer to section 21.1.1, System Clock Control Register (SCKCR).
• System clock control register (SCKCR)

• Standby control register (SBYCR)

• Module stop control register H (MSTPCRH)
• Module stop control register L (MSTPCRL)
• Extension module stop control register H (EXMSTPCRH)
• Extension module stop control register L (EXMSTPCRL)
22.1.1 Standby Control Register (SBYCR)
SBYCR performs software standby mode control.
Bit Bit Name
7 SSBY
6 OPE
Rev. 1.0, 09/01, page 804 of 904
Initial Value R/W
0 R/W
1 R/W
Description
Software Standby
This bit specifies the transition mode after
executing the SLEEP instruction
0: Shifts to sleep mode after the SLEEP instruction
is executed
1: Shifts to software standby mode after the SLEEP
instruction is executed
This bit does not change when clearing the
software standby mode by using external interrupts
and shifting to normal operation. This bit should be
written 0 when clearing.
Output Port Enable
Specifies whether the output of the address bus
and bus control signals (&63 to &6:, $6, 5',
+:5, /:5, 8&$6,#/&$6) is retained or set to the
high-impedance state in software standby mode.
0: In software standby mode, address bus and bus
control signals are high-impedance
1: In software standby mode, address bus and bus
control signals retain output state