3.1
Operating Mode Selection
This LSI supports only operating mode 7, that is, the advanced single-chip mode. The operating
mode is determined by the setting of the mode pins (MD2 to MD0). Only mode 7 can be used in
this LSI. Therefore, all mode pins must be fixed high, as shown in table 3.1. Do not change the
mode pin settings during operation.
Table 3.1
MCU Operating Mode Selection
MCU
Operating
Mode
MD2 MD1 MD0
7
1
1
3.2
Register Descriptions
The following registers are related to the operating mode.
• Mode control register(MDCR)
• System control register(SYSCR)
Section 3 MCU Operating Modes
CPU
Operating
Mode
1
Advanced
mode
Description
Single-chip mode
External Data Bus
On-Chip
Initial
ROM
Width
Enabled
Rev. 1.0, 09/02, page 47 of 568
Max.
Width