Using Device Clear To Halt Measurements; Summary Of Commands - Keysight N432A Programming Manual

1 N432A Remote Operation

Using Device Clear to Halt Measurements

Device Clear is an IEEE-488 low-level bus message which can be used to halt
measurements in progress. The status registers, error queue, and all configuration
states are left unchanged when a Device Clear message is received. Device Clear
performs the following actions:
– All measurements in progress are aborted.
– The N432A returns to the trigger "idle state".
– The N432A input and output buffers are cleared.
– The N432A is prepared to accept a new command string.
For interfaces that do not support a low-level Device Clear, use the
NOTE
command.

Summary of Commands

For details of each SCPI command available to program the N432A, refer to later
chapters for more details on each command.
For commands that require you to specify a window, the upper window is
represented by a 1 and the lower window by a 2. If you omit the window number,
the upper window is assumed.
116 Keysight N432A Programming Guide
ABORt[1]