Virtual-Address - Dell S6000 Reference Manual

00:00:5e:00:01:14
Virtual IP address:
10.0.0.2
Authentication: (none)
FTOS#show vrrp vrf jay brief
Interface Group
addr(s)
---------------------------------------------------------------
-----------------------------------
Fo 0/124
Dell#

virtual-address

Configure up to 12 IP addresses of virtual routers in the VRRP group. To start sending VRRP packets, set at
least one virtual address for the VRRP group.
S6000
Syntax
virtual-address ip-address1 [... ip-address12]
To delete one or more virtual IP addresses, use the no virtual-address ip-
address1 [... ip-address12] command.
Parameters
ip-address1
... ip-address12
Defaults Not configured.
Command VRRP
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0
Version
8.3.19.0
Version 8.3.11.1
Version 8.3.7.0
Version 7.6.1.0
Version 7.5.1.0
1506
Pri Pre State
Description
IPv4 20 100 Y Master 10.0.0.3
Enter an IP address of the virtual router in dotted decimal
format. The IP address must be on the same subnet as the
interface's primary IP address.
(OPTIONAL) Enter up to 11 additional IP addresses of virtual
routers in dotted decimal format. Separate the IP addresses
with a space. The IP addresses must be on the same subnet
as the interface's primary IP address.
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the S-Series.
Introduced on the C-Series.
Master addr Virtual
10.0.0.2
Virtual Router Redundancy Protocol (VRRP)