Vrrp-Group - Dell S6000 Reference Manual

•
Save the configuration and reload the system for the delay timers to take effect.
Related vrrp delay minimum
Command reboot.

vrrp-group

Assign a VRRP ID to an interface. You can configure up to 12 VRRP groups per interface.
S6000
Syntax
vrrp-group vrrp-id
Parameters
vrrp-id
Defaults Not configured.
Command INTERFACE
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0
Version
8.3.19.0
Version 8.3.11.1
Version 8.3.7.0
Version 7.6.1.0
Version 7.5.1.0
pre-Version
6.2.1.1
Usage The VRRP group only becomes active and sends VRRP packets when a virtual IP
Information address is configured. When you delete the virtual address, the VRRP group stops
sending VRRP packets.
Related virtual-address
Command
Virtual Router Redundancy Protocol (VRRP)
When an interface comes up, whether as part of a system reload or an interface
reload, the system waits 300 seconds (5 minutes) to bring up VRRP on that
interface.
— sets the delay time for VRRP initialization after a line card
Enter a number as the group ID. The range is from 1 to 255.
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the S-Series.
Introduced on the C-Series.
Introduced on the E-Series.
— assigns up to 12 virtual IP addresses per VRRP group.
1509