Version - Dell S6000 Reference Manual

version

Set VRRP protocol version for IPv4 group.
Syntax
version {2 | 3 | both}
To return to the default setting, use the no version command.
Parameters
2
3
both
Defaults 2
Command VRRP
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.5(0.0)
Usage You can use the version both command to migrate from VRRPv2 to VRRPv3. When
Information you set the VRRP protocol version to both, the switch sends only VRRPv3
advertisements but can receive either VRRPv2 or VRRPv3 packets. To migrate an
IPv4 VRRP group from VRRPv2 to VRRPv3:
1.
2.
3.
Example
Dell(conf-if-te-0/0-vrid-100)#version ?
2
3
both
both
Dell(conf-if-te-0/0-vrid-100)#version 3
1510
Enter the 2 parameter to specify VRRP version 2 as defined
by RFC 3768, Virtual Router Redundancy Protocol.
Enter the 2 parameter to specify VRRP version 3 as defined
in RFC 5798, Virtual Router Redundancy.
Enter the both keyword for in-service migration from VRRP
version 2 to VRRP version 3.
Introduced on the Z9000, S6000, S4820T, S4810, and MXL.
Set the switches with the lowest priority to "both".
Set the switch with the highest priority to version to 3.
Set all the switches from both to version 3.
NOTE: Do not run VRRP version 2 and version 3 in the same group for an
extended period of time.
VRRPv2
VRRPv3
Interoperable, send VRRPv3 receive
Virtual Router Redundancy Protocol (VRRP)