Show Ip Ospf Database - Dell Z9500 Reference Manual

determine if the path to the originating router is correct. The display output is not
sorted in any order.
You can determine if an ASBR is in a directly connected area (or not) by the flags.
For ASBRs in a directly connected area, E flags are set. In the following example,
router 1.1.1.1 is in a directly connected area since the Flag is E/-/-/. For remote
ASBRs, the E flag is clear (-/-/-/).
Example
Dell#show ip ospf 1asbr
RouterID
3.3.3.3
1.1.1.1
Dell#

show ip ospf database

Display all LSA information. If you do not enable OSPF on the switch, no output is generated.
Z9500
Syntax
show ip ospf process-id database [database-summary]
Parameters
process-id
database-
summary
Command
•
Modes
•
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.2(1.0)
8.3.19.0
8.3.11.1
8.3.7.0
7.8.1.0
Open Shortest Path First (OSPFv2 and OSPFv3)
NOTE: ASBRs that are not in directly connected areas are also displayed.
Flags Cost Nexthop
-/-/-/ 2
E/-/-/ 0
Enter the OSPF Process ID to show a specific process. If no
Process ID is entered, command applies only to the first
OSPF process.
(OPTIONAL) Enter the keywords database-summary to the
display the number of LSA types in each area and the total
number of LSAs.
EXEC
EXEC Privilege
Description
Introduced on the Z9500.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Added support of Multi-Process OSPF.
Interface Area
10.0.0.2 Te 0/1
0.0.0.0 -
1
0
1263