Draining And Adding Of Coolant - SSANGYONG 2004 Rexton 2.7XDi Workshop Manual

DI06-28
CHANGED BY
EFFECTIVE DATE
AFFECTED VIN

Draining and Adding of Coolant

1. Release the pressure from coolant reservoir by loosening
one notch of coolant reservoir cap, and then remove the
cap.
Notice
Scalding hot coolant and steam could be blown out
under pressure, which could cause serious injury.
Never remove the coolant reservoir cap when the
before the temperature goes down below 90°C.
Y220_06061
2. Loosen the drain plug in bottom of radiator and drain the
coolant.
Notice
Collect the drained coolant with a proper container.
Y220_06062
3. Remove the drain plug (1) and seal (2) in the cylinder
block and drain the coolant.
4. Replace the seal with new one and install the drain plug.
Installation Notice
Tightening torque
Y220_06063
5. Install the drain plug in bottom of radiator.
6. Add the coolant through the coolant reservoir.
Notice
• Keep the coolant mixture ratio of 50:50 (water : anti-
freezer).
• Add the coolant until the water flows out through
the overflow hose.
7. Warm up the engine until the thermostat begins to open
and check if the coolant level is at "FULL" mark on the
reservoir. Add if necessary.
30 Nm
COOLING SYSTEM
DI ENG SM - 2004.4