Front And Rear Band Adjustment - SSANGYONG Y200 Manual

Hide thumbs Also See for Y200:

Table of Contents

1. Measure the projection of the front servo push rod

from the transmission case dimension 'A'.

a. Apply air at 650/700 kPa to the front servo apply

area (B1 outer)

b. Measure the travel of the push rod and subtract

3 mm to find the shim size required.

c. Release the air.

Notice: A minimum of one shim is required at all times

- minimum shim size is 1 mm. The thickness of

available shims are listed in the table below.

Thickness(mm)

SSANGYONG Y200

FRONT AND REAR BAND ADJUSTMENT

Front Band Setting Procedure

AUTOMATIC TRANSMISSION 5A-201

2. Fit the selected shim(s) to the shank of the anchor

strut as follows:

a. Inspect the shim(s) for damage, wear or corro-

sion. Replace as necessary.

b. The shim(s) are to be installed between the case

abutment face and the anchor strut flange.

c. The shim(s) are to be fitted by hand and under

no circumstances to be hammered or forced.

d. Shim(s) are to be pressed on by hand until an

audible click is heard. The click indicates that

the shim is clipped home correctly.

3. Re-check that the push rod travel. (3mm ±0.25mm)

Table of Contents