SSANGYONG 2004 Rexton 2.7XDi Workshop Manual page 302

DI07-44
CHANGED BY
EFFECTIVE DATE
AFFECTED VIN
Removal and Installation
Preceding Work: Removal of engine cover
1. Disconnect the fuel pressure sensor connector.
Notice
• Replace the fuel pipes with new ones.
• Plug the openings of hole in the common rail with
sealing caps.
• Check pressure is low before opening the circuit.
Y220_07090
2. Unscrew the nuts and remove the fuel supply main pipe
from the fuel line.
Installation Notice
Tightening torque
Notice
• Replace the fuel pipes with new ones.
• Plug the openings of hole in the common rail with
sealing caps.
3. Unscrew the high fuel pressure line nuts and remove the
Y220_07092
fuel pipes.
Installation Notice
Tightening torque
Notice
• Replace the fuel pipes with new ones.
• Plug the openings of hole in the common rail with
sealing caps.
4. Unscrew the bolts and remove the common rail
asssembly.
Installation Notice
Tightening torque
Notice
• Replace the fuel pipes with new ones.
• Plug the openings of hole in the common rail with
sealing caps.
5. Install in the reverse order of removal.
Y220_07093
40 ± 10 Nm
40 ± 10 Nm
25 ± 2.5 Nm
FUEL SYSTEM
DI ENG SM - 2004.4