SSANGYONG 2004 Rexton 2.7XDi Workshop Manual page 294

DI07-36
Notice
If the initialization of fuel pressure has not been
performed, the engine ECU controls new HP pump
with the stored offset value. This may cause the
poor engine output.
CHANGED BY
EFFECTIVE DATE
AFFECTED VIN
17. Install the coolant pump pulley.
Tightening torque
Y220_07077
18. Install the fan clutch with a special tool.
Tightening torque
19. Install the oil dipstick tube and bracket.
Tightening torque
Y220_07078
20. Install the exhaust EGR pipe and bracket.
Tightening torque
Notice
Make sure that the convex
surface of new steel gasket
is facing the direction as
shown in the figure.
21. Engage the turbo charger and PCV separator connecting
lines.
Y220_07079
22. Engage the air cleaner hose and tighten the clamp.
23. Connect the HFM sensor connector.
24. Install the EGR center pipe.
Tightening torque
25. Connect the HP pump connectors and engage the hose lines.
- Fuel temperature sensor connectors and IMV connector
- Venturi hose and fuel return hose
26. Install the coolant temperature sensor and the knock sensor.
27. When replaced the HP pump, initialize the fuel pressure
by using Scan-i. Refer to "Trouble Diagnosis" section in
this manual.
10 ± 1.0 Nm
10 ± 1.0 Nm
10 ± 1.0 Nm
10 ± 1.0 Nm
Gasket
Installing
direction
25 ± 2.5 Nm
FUEL SYSTEM
DI ENG SM - 2004.4