SSANGYONG 2004 Rexton 2.7XDi Workshop Manual page 418

DI10-58
DTC Trouble
P0222 Accelerator Pedal Sensor
#2 Malfunction - Open
P0223 Accelerator Pedal Sensor
#2 Malfunction - Short
P0220 Accelerator Pedal Sensor
#2 Malfunction - Supply
Voltage Fault
P0192 Fuel Rail Pressure Sensor
Malfunction - Open
CHANGED BY
EFFECTIVE DATE
AFFECTED VIN
Help
- Out of range about potentiometer 2 of
pedal sensor: lower than specified
values
- Check the supply voltage to sensor.
- Check the wiring harness.
• Check the circuit for open and short.
• Check the ECU pin #32, #14 for open
and poor contact.
- Check the accelerator pedal.
- Check the ECU wiring harness.
- Replace the ECU if required.
- Out of range about potentiometer 2 of
pedal sensor: higher than specified
values
- Check the supply voltage to sensor.
- Check the wiring harness.
• Check the circuit for open and short.
• Check the ECU pin #32, #14 for short
and poor contact.
- Check the accelerator pedal.
- Check the ECU wiring harness.
- Replace the ECU if required.
- The supply voltage is faulty.
- Check the supply voltage to sensor.
- Check the wiring harness.
• Check the circuit for open and short.
• Check the ECU pin #57, #14 for open
and short.
- Check the accelerator pedal.
- Check the ECU wiring harness.
- Replace the ECU if required.
- The fuel rail pressure sensing values
are lower than specified values.
• Minimum sensing values: - 1 1 2
bar (Open)
- Check the supply voltage to sensor.
• Output voltage at 1600 bar: 4.055 ±
0.125 V
• Output voltage at atmospheric
pressure: 0.5 ± 0.04 V
- Check the sensor and ECU wiring
harness.
• Check the ECU pin #25, #26 for open
and poor contact.
• Check the fuel rails and high pres-
sure pipes for leaks.
- Check the fuel rail pressure sensor.
- Replace the ECU if required.
Torque Torque Delayed
Reduction Reduction Engine
(max.50%) (max.20%) Stop
O
O
O
O
Immediately Limp
Engine Home
Stop Mode
DIAGNOSIS
DI ENG SM - 2004.4