SSANGYONG 2004 Rexton 2.7XDi Workshop Manual page 291

Installation
1. Install the gasket and HP pump.
Notice
Replace the removed gasket with new one.
Warning
Remove caps at last minute and always change removed HP pipes.
2. Install the HP pump bearing bracket and HP pump to the
cylinder block.
Tightening torque
Notice
Align the oil galleries in cylinder block and bearing
bracket.
3. Install the bearing into the bracket.
4. Temporarily install the upper and lower guide rails to seat
the chain.
5. Temporarily tighten the center nut for HP pump shaft.
Notice
Be careful not to rotate the shaft.
6. Install the timing chain on the sprocket and lock the
sprocket with a special tool.
Notice
Do not apply excessive force to the timing chain.
Otherwise, the TDC point deviates from correct
position.
FUEL SYSTEM
DI ENG SM - 2004.4
24 ± 2.4 Nm
DI07-33
Y220_07065
Y220_07067
Y220_07068
CHANGED BY
EFFECTIVE DATE
AFFECTED VIN