Cam-Acl-Egress; Cam-Optimization - Dell Force10 Z9000 Reference Manual

Ranges for the CAM profiles are 1 to 10, except for the ipv6acl profile which is 0 to 10. The
ipv6acl allocation must be a factor of 2 (2, 4, 6, 8, 10).
If BMP 3.0 is enabled, use the command reload conditional nvram-cfg-change
to perform a reload on the chassis to upgrade any configuration changes that have changed
the NVRAM content.

cam-acl-egress

Allocate CAM for egress ACLs.
S-Series (S60), Z-Series, S4810
Syntax cam-acl-egress default | l2acl
Parameters
default
l2acl
Command Modes CONFIGURATION
Command History
Version 8.3.11.1

cam-optimization

Optimize CAM utilization for QoS Entries by minimizing require policy-map CAM space.
C-Series, S-Series, Z-Series
Syntax cam-optimization [qos]
Parameters
qos
Defaults Disabled.
Command Modes CONFIGURATION
Command History
Version 8.3.11.1
Version 8.2.1.0
Version 7.8.1.0
Usage When you enable this command, if a Policy Map containing classification rules (ACL and/or
Information dscp/ ip-precedence rules) is applied to more than one physical interface on the same port
pipe, only a single copy of the policy is written (only one FP entry is used).
Reset egress CAM ACL entries to default settings.
number
Allocate space for Layer 2 egress ACL. The range is 1 to 4 FP blocks.
Introduced on the Z9000.
Optimize CAM usage for QoS.
Introduced on the Z9000.
Introduced on the S-Series.
Introduced on the C-Series.
NOTE: An ACL itself may still require more that a single FP entry, regardless of the number
of interfaces. For more information, refer to the "IP Access Control Lists", "Prefix Lists",
and "Route-map" sections in the FTOS Configuration Guide .
549