Rap 5 C5: Add Paper To Mbf, Tray 1, 2 Or 3) - Xerox DocuPrint N2025 Service Manual

RAP 5 C5: Add Paper To MBF, Tray 1, 2 or 3)

Procedure
The problem appears when using Tray 2 or 3.
Y N
Check the paper level in Tray 1. There is at least 100 sheets of paper in Tray 1.
Y N
Load paper into Tray 1.
Check the paper level in the MBF. There is paper in the MBF.
Y N
Load paper into the MBF.
Enter Diagnostics and select Test Print. Run a test print from the MBF Tray (see section
6). The C5 error code appears when you feed paper from MBF.
Y N
Run a test print from the Tray 1. The C5 error code appears when you feed paper
from Tray 1.
Y N
Return to Initial Actions and restart.
Remove Tray 1 from the printer. Remove the Tray Cover, if installed, and all paper
from the tray. Insert Tray 1 into the printer and inspect the Bottom Plate. The
tom Plate is raised fully and evenly.
Y N
Replace the Tray 1 Assembly (PL 2.1/ PL 2.2).
Remove Tray 1. Manually actuate the Tray 1 No Paper and Low Paper sensors. The
No Paper and Low Paper Actuators move smoothly.
Y N
Replace the Tray 1 No Paper Actuator (REP 2.6) or Low Paper Actuator (PL
3.1).
NOTE: When checking the Low Paper Sensor using the Sensor Test, at least one
Paper Size switch and the Low Paper Sensor must be actuated.
Enter Diagnostics and select Component Test. Scroll to Sensor Input Test and press
Enter. Manually actuate the Tray 1 No Paper and Low Paper Sensors. The number
on the LCD increments each time you press and release one of the actuators.
Y N
Go to RAP 34.
Replace the Print Engine Controller PWB (REP 8.5).
Insert then remove a piece of paper into the MBF. The MBF No Paper Actuator moves
smoothly when paper is inserted then removed.
Y N
Repair or replace the actuator, as necessary.
Enter Diagnostics and select Component Test. Scroll to Sensor Input Test and press
Enter. Manually actuate the MBF No Paper Sensor. The number on the LCD incre-
ments each time you press and release the actuator.
A
Initial Issue
DocuPrint N2025/N2825
A
Y N
Go to RAP 33.
Replace the Print Engine Controller PWB (REP 8.5).
Go to RAP 47.
Bot-
02/2000
2-15
Status Indicator Repair Analysis Procedures
RAP 5