Rep 6.1 Main Gear Drive Assembly - Xerox DocuPrint N2025 Service Manual

REP 6.1 Main Gear Drive Assembly

Parts List on PL 7.1
Removal
Switch off the power and disconnect the Power Cord.
1. Remove the Lower Rear Cover (REP 1.7).
2. Open the Rear Cover.
3. Remove the Fuser Assembly (REP 5.1).
4. Open the Top Cover and remove the Print Cartridge. Cover the cartridge to protect it from
light.
5. Remove Tray 1.
6. Remove the MBF Assembly (REP 2.1).
7. Remove the Left Side Cover (REP 1.1).
8. Remove the Top Cover Assembly (REP 1.3).
9. Loosen the two thumb screws and remove the System Controller PWB Shield Cover (Fig-
ure 1).
10. Remove the System Controller PWB (REP 8.1).
11. Disconnect CN2 from the Motor Drive PWB (Figure 2).
NOTE: In the next step, there are arrows stamped into the metal indicating the eight
screws to remove.
12. Remove the eight screws that secure the Gear Assembly to the printer (Figure 2).
13. Remove the Gear Assembly and Motor from the printer (Figure 2).
Figure 1 Shield Cover
Initial Issue
DocuPrint N2025/N2825
WARNING
Figure 2 Gear Drive Assembly
Replacement
1. Reinstall the components in the reverse order.
02/2000
4-35
Repair-Adjustment
REP 6.1