Rep 10.6 Inner Exit Chute Assembly; Rep 10.7 Offset Catch Tray Pwb - Xerox N2125N - DocuPrint B/W Laser Printer Service Manual

REP 10.6 Inner Exit Chute Assembly

Parts List on PL 14.1
Removal
Switch off the power and disconnect the Power Cord.
1. Remove the Offset Catch Tray (REP
2. Remove the Exit Tray Extension (REP
3. Remove the Exit Tray (REP 10.3).
4. Turn the Offset Catch Tray upside down.
5. Remove the Lower Cover (REP 10.5).
6. Remove the five screws that secure the Inner Exit Chute Assembly
7. Hold open the Rear Cover.
8. Remove the assembly (Figure 1).
Figure 1 Inner Exit Chute Assembly
Replacement
1. Reinstall the components in the reverse order.
Repair-Adjustment
REP 10.6, REP 10.7
WARNING
10.1).
10.2).
(Figure

REP 10.7 Offset Catch Tray PWB

Parts List on PL 14.2
Removal
These components are susceptible to electrostatic discharge. Observe all ESD procedures to
avoid damage.
Switch off the power and disconnect the Power Cord.
1. Remove the Offset Catch Tray
2. Remove the Exit Tray Extension
3. Remove the Exit Tray
1).
4. Turn the Offset Catch Tray upside down.
5. Remove the Lower Cover
6. Hold open the Rear Cover.
7. Remove the Inner Exit Chute Assembly
8. Remove the screw that secures the PWB to the Inner Exit Chute Assembly
9. Disconnect P/J209, P/J224, P/J210, and P/J229
10. Remove the Offset Catch Tray PWB
Replacement
1. Reinstall the components in the reverse order.
02/2000
4-70
CAUTION
WARNING
(REP 10.1).
(REP 10.2).
(REP 10.3).
(REP 10.5).
(REP 10.6).
(Figure 1).
(Figure 1).
Figure 1 Offset Catch Tray PWB
(Figure 1).
Initial Issue
DocuPrint N2125