To do...
Enter system view
Enter Layer 2 aggregate
interface view
Configure the load
sharing mode for the
aggregation group
Displaying and Maintaining Link Aggregation
To do...
Display the local system ID
Display the global or
aggregation group-specific load
sharing mode
Display link aggregation details
of ports
Display the summary
information of all aggregation
groups
Display detailed information of
aggregation groups
Clear the LACP statistics of
ports
Clear the statistics of the
specified aggregate interfaces
Link Aggregation Configuration Examples
Layer 2 Static Aggregation Configuration Example
Network requirements
As shown in
Figure
GigabitEthernet1/0/1 to GigabitEthernet1/0/3.
Use the command...
system-view
interface bridge-aggregation
interface-number
link-aggregation load-sharing mode
{ destination-ip | destination-mac |
source-ip | source-mac } *
Use the command...
display lacp system-id
display link-aggregation
load-sharing mode [ interface
[ bridge-aggregation
interface-number ] ]
display link-aggregation
member-port [ interface-type
interface-number [ to interface-type
interface-number ] ]
display link-aggregation
summary
display link-aggregation verbose
[ bridge-aggregation
[ interface-number ] ]
reset lacp statistics [ interface
interface-type interface-number [ to
interface-type interface-number ] ]
reset counters interface
[ bridge-aggregation
[ interface-number ] ]
1-1, Device A and Device B are connected through their respective Ethernet ports
1-10
Remarks
—
—
Required
By default, the load
sharing mode of an
aggregation group is the
global load sharing mode.
After you configure this
command, the load
sharing modes in current
link aggregation group
change accordingly.
Remarks
Available in any view
Available in any view
Available in any view
Available in any view
Available in any view
Available in user view
Available in user view