Enabling The Traffic Statistics Feature On An Ethernet Subinterface; Displaying And Maintaining An Ethernet Interface Or Subinterface - H3C SR6602-X Configuration Manual

Step
3. Change the interface to a
Layer 3 GigabitEthernet
interface.
Enabling the traffic statistics feature on an Ethernet
subinterface
This command is resource intensive. When you use this feature, make sure you fully understand its
impact on system performance.
To enable the traffic statistics feature on an Ethernet subinterface:
Step
1. Enter system view.
2. Enter Ethernet
subinterface view.
3. Enable the traffic
statistics feature on
the Ethernet
subinterface.
4. (Optional.) Display
the traffic statistics
for an Ethernet
subinterface.
Displaying and maintaining an Ethernet interface
or subinterface
Execute display commands in any view and reset commands in user view.
Task
Display interface traffic statistics.
Display traffic rate statistics of interfaces
in up state over the last statistics polling
interval.
Display the operational and status
information of the specified interfaces.
Display the Ethernet module statistics (in
standalone mode).
Display the Ethernet module statistics (in
IRF mode).
Clear interface or subinterface statistics.
Command
port-type switch gigabitethernet
Command
system-view
interface interface-type
interface-number.subnumber
traffic-statistic enable
•
display interface
•
display counters
Command
display counters { inbound | outbound } interface
[ interface-type [ interface-number |
interface-number.subnumber ] ]
display counters rate { inbound | outbound } interface
[ interface-type [ interface-number |
interface-number.subnumber ] ]
display interface [ interface-type [ interface-number |
interface-number.subnumber ] ] [ brief [ description | down ] ]
display ethernet statistics slot slot-number
display ethernet statistics chassis chassis-number slot
slot-number
reset counters interface [ interface-type [ interface-number |
interface-number.subnumber ] ]
12
Remarks
The device enters Layer 3
GigabitEthernet interface view
automatically after you execute
this command.
Remarks
N/A
N/A
By default, the traffic statistics feature is
disabled on an Ethernet subinterface.
Use the Input or Output fields in the
display interface command output or use
the display counters command to
display the traffic statistics for the
Ethernet subinterface.