Clearing Unused 16-Bit Interface Indexes; Verifying And Diagnosing Transceiver Modules; Verifying Transceiver Modules - H3C S5500-HI Series Fundamentals Configuration Manual

Clearing unused 16-bit interface indexes

The device must maintain persistent 16-bit interface indexes and keep one interface index match one
interface name for network management. After deleting a logical interface, the device retains its 16-bit
interface index so the same index can be assigned to the interface at interface re-creation.
To avoid index depletion causing interface creation failures, you can clear all 16-bit indexes that have
been assigned but not in use. The operation does not affect the interface indexes of the interfaces that
have been created but the indexes assigned to re-recreated interfaces might change.
Follow the step below to clear unused 16-bit interface indexes:
To do...
Clear unused 16-bit interface
indexes
CAUTION:
In an IRF fabric, the command applies to all member switches.
•
A confirmation is required when you execute this command. The command will not run if you fail to
•
make a confirmation within 30 seconds or enter N to cancel the operation.

Verifying and diagnosing transceiver modules

NOTE:
Support for the pluggable transceivers and the transceiver type depends on the device model.

Verifying transceiver modules

You can verify the genuineness of a transceiver module in the following ways:
• Display the key parameters of a transceiver module, including its transceiver type, connector type,
central wavelength of the transmit laser, transfer distance and vendor name.
Display its electronic label. The electronic label is a profile of the transceiver module and contains
•
the permanent configuration including the serial number, manufacturing date, and vendor name.
The data is written to the storage component during debugging or testing.
Perform the following commands in any view to verify transceiver modules:
To do...
Display key parameters of transceiver modules
Display electronic label data for transceiver modules
Use the command...
reset unused porttag
Use the command...
display transceiver interface [ interface-type
interface-number ] [ | { begin | exclude | include }
regular-expression ]
display transceiver manuinfo interface [ interface-type
interface-number ] [ | { begin | exclude | include }
regular-expression ]
159
Remarks
Required
Available in user view.