Route Capacity Configuration Commands; Display Memory - H3C s3600 series Command Manual

6

Route Capacity Configuration Commands

The term router in this chapter refers to a router in a generic sense or an Ethernet switch running a
routing protocol.
The S3600-SI series do not support route capacity configuration.
Route Capacity Configuration Commands

display memory

Syntax
display memory [ unit unit-id ]
Mode
Any view
Parameters
unit-id: Unit ID.
Description
Use the display memory command to display the memory usage.
Examples
# Display the current memory usage of the switch.
<Sysname> display memory
Unit 1
System Available Memory(bytes): 33631488
System Used Memory(bytes): 16122304
Used Rate: 47%
The following table describes the fields of the command:
Table 6-1 Description on the fields of the display memory command
Unit
System Available Memory(bytes)
System Used Memory(bytes)
Field Description
Specifies a Unit ID
Free memory size, in bytes, of the switch
Occupied memory size, in bytes, of the switch
6-1