Master Node Configuration Example; Configuring Transit Node; Configuration Procedure - H3C S5500-EI series Operation Manual

Hide thumbs Also See for S5500-EI series:

Table of Contents

Operation Manual – RRPP

H3C S5500-EI Series Ethernet Switches

The control VLAN configured for an RRPP domain must be a new one.

Control VLAN configuration is required for configuring an RRPP ring.

To use the undo rrpp domain command to remove an RRPP domain, you must

ensure the RRPP domain has no RRPP ring.

1.3.2 Master Node Configuration Example

I. Network requirements

Specify the device in RRPP domain 1;

Set VLAN 4092 as the control VLAN;

Specify the device as the master node of primary ring 1 in RRPP domain 1,

GigabitEthernet 1/0/1 as the primary port and GigabitEthernet 1/0/2 as the

secondary port;

Set the Hello timer value to 2 seconds and the Fail timer value to 7 seconds.

II. Configuration procedure

<Sysname> system-view

[Sysname] interface gigabitethernet 1/0/1

[Sysname-GigabitEthernet1/0/1] link-delay 0

[Sysname-GigabitEthernet1/0/1] quit

[Sysname] interface gigabitethernet 1/0/2

[Sysname-GigabitEthernet1/0/2] link-delay 0

[Sysname-GigabitEthernet1/0/2] quit

[Sysname] rrpp domain 1

[Sysname-rrpp-domain1] control-vlan 4092

[Sysname-rrpp-domain1] ring 1 node-mode master primary-port gigabitethernet

1/0/1 secondary-port gigabitethernet 1/0/2 level 0

[Sysname-rrpp-domain1] timer hello-timer 2 fail-timer 7

[Sysname-rrpp-domain1] ring 1 enable

[Sysname-rrpp-domain1] quit

[Sysname] rrpp enable

Follow these steps to configure transit node:

Chapter 1 RRPP Configuration

Table of Contents