Enabling The System To Test Connected Cable; Configuring The Interval To Perform Statistical Analysis On Port Traffic; Disabling Up/Down Log Output On A Port - H3C S3100 Series Operation Manual

Enabling the System to Test Connected Cable

You can enable the system to test the cable connected to a specific port. The test result will be returned
in five seconds. The system can test these attributes of the cable: Receive and transmit directions (RX
and TX), short circuit/open circuit or not, the length of the faulty cable.
Table 1-8 Enable the system to test connected cables
Operation
Enter system view
Enter Ethernet port view
Enable the system to test
connected cables
Currently, the device is only capable of testing the cable status and cable length. For the testing
items that are currently not supported, "-" is displayed in the corresponding output fields.
Cable test cannot be performed on an optical port.

Configuring the Interval to Perform Statistical Analysis on Port Traffic

By performing the following configuration, you can set the interval to perform statistical analysis on the
traffic of a port.
When you use the display interface interface-type interface-number command to display the
information of a port, the system performs statistical analysis on the traffic flow passing through the port
during the specified interval and displays the average rates in the interval. For example, if you set this
interval to 100 seconds, the displayed information is as follows:
Last 100 seconds input:
Last 100 seconds output:
Table 1-9 Set the interval to perform statistical analysis on port traffic
Operation
Enter system view
Enter Ethernet port view
Set the interval to perform
statistical analysis on port traffic

Disabling Up/Down Log Output on a Port

An Ethernet port has two physical link statuses: UP and Down. When the physical link status of an
Ethernet port changes, the switch will send log to the log server, which in turn acts accordingly. If the
Command
system-view
interface interface-type interface-number
virtual-cable-test
0 packets/sec 0 bytes/sec
0 packets/sec 0 bytes/sec
Command
system-view
interface interface-type
interface-number
flow-interval interval
1-8
Remarks
—
—
Required
Description
—
—
Optional
By default, this interval is 300
seconds.