Set Ip Next-Hop (Route Map) - Allied Telesis x310-26FT Command Reference Manual

R M C
OUTE AP OMMANDS
- ( )
SET IP NEXT HOP ROUTE MAP

set ip next-hop (route map)

Overview Use this command to add a next-hop set clause to a route map entry.
When a route matches the route map entry, the device sets the route's next hop to
the specified IP address.
Use the no variant of this command to remove the set clause.
set ip next-hop <ip-address>
Syntax
no set ip next-hop [<ip-address>]
Mode Route-map Configuration
Usage Use this command to set the next-hop IP address to the routes.
This command is valid for:
•
•
To use entry 3 of the route map called mymap to give matching routes a next hop
Example
of 10.10.0.67, use the commands:
awplus#
awplus(config)#
awplus(config-route-map)#
Related match ip next-hop
Commands
route-map
show route-map
C613-50103-01 REV A
Parameter Description
<ip-address>
The IP address of the next hop, entered in the form A.B.C.D.
OSPF routes
RIP routes.
configure terminal
route-map mymap permit 3
Command Reference for x310 Series
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
set ip next-hop 10.10.0.67
1074