Create Tunnel Ipv6-In-Ipv4 - Extreme Networks ExtremeWare XOS Command Reference Manual

create tunnel ipv6-in-ipv4

create tunnel <tunnel_name> ipv6-in-ipv4 destination <destination-address>
source <source-address>
Description
Creates an IPv6-in-IPv4 (6in4) tunnel.
Syntax Description
tunnel_name
source-address
Default
N/A.
Usage Guidelines
This command will create a new IPv6-in-IPv4 (otherwise known as a configured tunnel or a 6in4 tunnel)
and add it to the system. A maximum of 255 tunnels (including one 6to4 tunnel) can be configured on
the system. The tunnel name must be unique and cannot overlap the same name space as VLANs, other
tunnels, or virtual routers. The source address of the tunnel must be one of the IPv4 addresses already
configured on the switch. You cannot remove an IPv4 address from the switch if a tunnel is still exists
that uses it.
Example
The following command creates the 6in4 tunnel link39 with destination address 10.10.10.10 and source
address 192.168.10.15:
create tunnel link39 ipv6-in-ipv4 destination 10.10.10.10 source 192.168.10.15
History
This command was first available in ExtremeWare XOS 11.2.
Platform Availability
This command is available on all platforms.
ExtremeWare XOS 11.3 Command Reference
Specifies an IPv6 tunnel.
Specifies an IPv4 address for the tunnel.
create tunnel ipv6-in-ipv4
1191