Honda Accord 2008 Manual page 235

Hide thumbs Also See for Accord 2008:

Table of Contents

07/11/02 09:09:29 61TA0000_070_0010

Engine Block

Connecting Rod Bearing Replacement (cont'd)

Connecting Rod Bearing Selection

1. Inspect each connecting rod for cracks and heat

Connecting Rod Big End Bore Code Locations

2. Each connecting rod has a tolerance range from 0

to 0.024 mm (0.0009 in.), in 0.006 mm (0.0002 in.)

increments, depending on the size of its big end

bore. It's then stamped with a number or bar (1, 2,

3, or 4/I, II, III, or IIII) indicating the range. You may

find any combination of numbers and bars in any

engine. (Half the number or bar is stamped on the

bearing cap, the other half is on the rod.)

If you can't read the code because of an

accumulation of oil and varnish, do not scrub it

with a wire brush or scraper. Clean it only with

solvent or detergent.

Normal Bore Size: 51.0 mm (2.01 in.)

Connecting Rod Journal Code Location

3. The connecting rod journal codes are stamped on

the crankshaft in either location.

No. 4 JOURNAL

No. 1 JOURNAL

Chapters

Table of Contents