STMicroelectronics SPC572L series Reference Manual page 2051

RM0400
Date
27-Feb-2015
Table 1150. Revision history(Continued)
Rev
Chapter 44, CAN Subsystem: substantial changes
Chapter 45, Serial Interprocessor Interface (SIPI)
Section 48.10.1, Initialization mode
initialization mode, all message transfers are stopped. If software
invokes..."
Section 48.10.3, Module disable
functionality
Table 865: SIPI_MCR field
to say that future SIPI Tx transfers are disabled when this bit is negated
Table 870: SIPI_ERR field
descriptions for field TOE3–TOE0
Chapter 48: Deserial Serial Peripheral Interface (DSPI)
Throughout chapter: removed all instances of registers "PISR" (PISR0–
PISR7) and relative content; removed "DMA request" feature content;
removed DOZE mode content.
Section 48.1.2,
DDIF" and "edge sensitive hardware trigger"; removed text "support for
doze mode".
Section 48.1.4.4, External Stop
Stop mode requests in DSPI Slave mode.
Rev 3
Table 749: DSPI signal
(cont'd)
available..."
Table 750: DSPI memory
"0201_0000h"
Section 48.3.1, DSPI Module Configuration Register
– Set bit 16 to "Reserved" (was field "DOZE")
– Removed text "parameterized, with a default reset value of" from "MDIS"
field description
Table 751: DSPI_MCR field
added sentence "MTFE should not be set in ITSB..."
Section 48.3.4, DSPI Clock and Transfer Attributes Register (In Slave
Mode)
"FMSZ5" (was "FMSZ[5]")
Figure 690 (DSPI DMA/Interrupt Request Select and Enable Register
(DSPI_RSER)): removed field "DDIF_DIRS" from bit 17
Figure 696 (DSPI DSI Configuration Register 0
– Added footnote to "TPOL" field "This bit is reserved if the device does..."
– Removed field "TRRE" from bit 13
– Renamed fields relative to bits 1 and 8 to "FMSZ4" and "FMSZ5"
respectively (were "FMSZ[4]" and "FMSZ[5]")
Updated Table 765: DSPI_DSICR0 field descriptions
DocID027809 Rev 4
Changes
(MD): added information to disable Rx
descriptions: revised "MOEN" field description
descriptions: revised binary combination
Features: removed features "DMA request support for
mode: added content relating to External
description: added footnote "This pin is not
map: added reset value of register "DSPIx_SR":
descriptions: in "MTFE" field description,
(DSPI_CTARn_SLAVE): renamed field relative to bit 9 to
Revision history
(INIT): removed paragraph "When in
(DSPI_MCR):
(DSPI_DSICR0)):
2051/2058
2057