Example For Configuring The Mac Address Table; Figure 6-1 Networking Diagram For Configuring The Mac Address Table - Huawei Quidway S9300 Configuration Manual

Quidway S9300 Terabit Routing Switch
Configuration Guide - Ethernet

6.6.1 Example for Configuring the MAC Address Table

6.6.2 Example for Configuring the Limitation on MAC Address Learning Based on VLAN
6.6.3 Example for Configuring the Limitation on MAC Address Learning Based on VSI
6.6.1 Example for Configuring the MAC Address Table
Networking Requirements
As shown in
address of the user host PC2 is 0003-0003-0003. PC1 and PC2 are connected to the S9300
through the LSW. The LSW is connected to GE 1/0/1 of the S9300. Interface GE 1/0/1 belongs
to VLAN 2. The MAC address of the server is 0004-0004-0004. The server is connected to GE
1/0/2 of the S9300. Interface GE 1/0/2 belongs to VLAN 2.
l
l

Figure 6-1 Networking diagram for configuring the MAC address table

MAC address: 2-2-2
Configuration Roadmap
The configuration roadmap is as follows:
Issue 03 (2009-08-20)
Figure 6-1, the MAC address of the user host PC1 is 0002-0002-0002 and the MAC
To prevent hackers from attacking the network with MAC addresses, you need to add a
static entry to the MAC table of the S9300 for each user host. When sending packets through
GE 1/0/1, the S9300 changes the VLAN ID to VLAN 4 to which the LSW belongs. In
addition, you need to set the aging time of the dynamic entries in the MAC address table
to 500 seconds.
To prevent hackers from forging the MAC address of the server and stealing user
information, you can configure the packet forwarding based on static MAC address entries
on the S9300.
MAN
S9300
GE1/0/2
VLAN2
GE1/0/1
LSW
VLAN4
PC1
MAC address: 3-3-3
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Server
MAC address: 4-4-4
PC2
6 MAC Address Table Configuration
6-11