Configuration Example; Example For Configuring The Pim-Dm Network - Huawei Quidway s3700 series Configuration Manual

Quidway S3700 Series Ethernet Switches
Configuration Guide - Multicast
l
l
l
----End

6.12 Configuration Example

Configuration examples are provided to show how to construct a basic PIM-DM network.

6.12.1 Example for Configuring the PIM-DM Network

Networking Requirements
On the experiment network shown in
normally. The S3700s on the network need to be configured properly so that hosts can receive
the VOD information in multicast mode.
Figure 6-2 Networking diagram for configuring basic PIM-DM functions
Source
Switch
Switch A
Switch B
Switch C
Issue 01 (2011-10-26)
Run the debugging pim assert [ advanced-acl-number | [ receive | send ] ]
the user view to enable the debugging of PIM Assert.
Run the debugging pim join-prune [ advanced-acl-number | [ receive | send ] ]
in the user view to enable the debugging of PIM Join/Prune.
Run the debugging pim state-refresh [ advanced-acl-number | [ receive | send ] ]
command in the user view to enable the debugging of PIM State-Refresh.
Ethernet
Eth0/0/4
SwitchD
Eth0/0/2
Physical interfaces
Eth0/0/1
Eth0/0/2
Eth0/0/1
Eth0/0/2
Eth0/0/1
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Figure 6-2, multicast is deployed. The unicast routes work
SwitchA
Eth0/0/2
Eth0/0/1
PIM-DM
Eth0/0/3
Eth0/0/1
Eth0/0/1
Eth0/0/1
Eth0/0/2
SwitchC
VLANIF interface
VLANIF100
VLANIF101
VLANIF200
VLANIF102
VLANIF300
6 PIM-DM (IPv4) Configuration
Ethernet
N1
Leaf network
Eth0/0/2
N2
SwitchB
Ethernet
IP address
192.168.1.1/24
10.110.1.1/24
192.168.2.1/24
10.110.2.1/24
192.168.3.1/24
*
command in
*
command
*
Receiver
HostA
Receiver
HostB
129