Checking The Configuration; Configuration Examples; Example For Configuring Poe On The Switch - Huawei Quidway S3700 Series Configuration Manual

Quidway S3700 Series Ethernet Switches
Configuration Guide - Device Management
1.
2.
3.
----End

9.3.4 Checking the Configuration

Prerequisite
The PoE power supply and PoE board are installed, and the PoE function is configured.
Procedure
Step 1 Run the display poe-power command to view the status of the PoE power supply.
Step 2 Run the display poe device command to view information about the devices that support the
PoE function.
Step 3 Run the display poe information command to view the PoE information.
Step 4 Run the display poe power interface interface-type interface-number command to view the
output power of an interface.
Step 5 Run the display poe power-state interface interface-type interface-number command to view
the status of PoE power supply on an interface.
----End

9.4 Configuration Examples

This section provides an example for configuring PoE on the S3700.

9.4.1 Example for Configuring PoE on the Switch

Networking Requirements
As shown in
through PoE.
Issue 01 (2011-07-15)
Run:
system-view
The system view is displayed.
Run:
interface interface-type interface-number
The interface view is displayed.
Run:
poe force-power
The interface is forcibly powered on.
By default, an interface cannot provide power for unidentified PDs.
Figure 9-1, Switch supports PoE. Switch A, Switch B, and the AP can be powered
NOTE
Switch A, Switch B, and the AP are devices of other vendors and need to be powered through PoE.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
9 PoE Configuration
124