Display Ntp-Service Sessions; Display Ntp-Service Status - Huawei Quidway S8500 Series Command Manual

Command Manual – System Management
Quidway S8500 Series Routing Switches
Example
# Enable NTP access control debugging.
<Quidway> debugging ntp-service access

7.1.2 display ntp-service sessions

Syntax
display ntp-service sessions [ verbose ]
View
Any view
Parameter
verbose: Indicates to display the detail information about the SESSIONS.
Description
Use the display ntp-service sessions command to display the status of all the
SESSIONS maintained by NTP service provided by the local equipment.
By default, the status of all the SESSIONS maintained by NTP service provided by the
local equipment will be displayed.
When you configure this command without the verbose parameter, the Ethernet switch
will display the brief information about all the SESSIONS it maintains.
With the verbose parameter configured, Ethernet switch will display the detail
information about all the SESSIONS it maintains.
Example
# Display status of all SESSIONS maintained by the local device NTP service.
<Quidway> display ntp-service sessions
source
********************************************************************
[12345]127.127.1.0 LOCAL(0) 7
note: 1 source(master),2 source(peer),3 selected,4 candidate,5 configured

7.1.3 display ntp-service status

Syntax
display ntp-service status
View
Any view
reference stra reach poll
Huawei Technologies Proprietary
Chapter 7 NTP Configuration Commands
now offset
377 64 16 0.0
7-2
delay disper
0.0 0.9