Executing Test Modes; Entering Test Mode Numbers - Riso ComColor X1 series Technical Manual

Test Modes

4. Executing Test Modes

4-1. Entering Test Mode Numbers

Selection from Menus
With this method, test modes are narrowed down by choosing options in Category and Processing Category (S, M,
U, I, C, or D) and the desired test mode is selected.
Entering Numbers Directly
With this method, the numeric keypad on the operation panel is used to enter the number when the printer is
awaiting input of the test mode.
To clear input errors, press the C button and enter the correct number.
Note: Leading zeros need not be entered. To enter 00100, you can simply enter 100.
4-2. Executing Test Modes
4-2-1. Sensor Monitoring (S)
After you select or enter the test mode number in step 4-1, pressing the Start key on the operation panel will
display a screen indicating the operation is paused. To cancel execution of test mode at this point, press the
Stop key.
To continue with execution, press the Start key again. Next, the screen indicates that operation is either
activated or deactivated.
When operation is activated, tones are emitted at short intervals.
When operation is deactivated, tones are emitted at long intervals.
S
01000 PFT U-LIMIT SENSOR A
In Pause
To return to the test mode standby screen, press the Stop key on the operation panel.
Rev.1.00
Test mode
To finish, press the Mode key
Catergory
00406 LOG PRINTOUT
System
00407 REV INFO PRINTOUT
Engine
00408 MANUAL EVENT CODE SETTING
Print head
00409 PANEL CALIBRATION
Option 1
00412 ADMIN SERVER COMMUNICATION TEST
Option 2
00413 TRANSMIT LOG SAVE
Scanner
Sensor
All
Close
Test mode No.
Drive Unit Initialize
Data Mon
I C
S M U
S
01000 PFT U=LIMIT SENSOR A
In Action
ON
S
01000 PFT U-LIMIT SENSOR A
In Action
OFF
[ 16-6 ]
00001
01/16
Data Edit
D
Tones at short intervals
Close
Check the details in
the Confi rmation Items
column for sensor
monitoring test modes.
Tones at long intervals
Close
Check the details in
the Confi rmation Items
column for sensor
monitoring test modes.