Riso ComColor X1 series Technical Manual page 72

External Paper Feed Section
9. Remove the elevator springs R & L.
Take caution in removing the elevator springs.
10. Remove the elevator motor assembly. (See section 2)
Hold the external paper feed tray to prevent it from dropping when removing the motor.
Elevator motor assembly
11. Remove the external paper feeding tray. (See section 2)
12. Remove the elevator support plate. (IT3C screw 4x8 (2 pc))
13. Remove the lower safety switch springs (front and rear).
14. Remove the lower limit frame holder. (IT 3x6 (1 pc))
15. Remove the lower limit frame.
16. Remove the elevator guides (front and rear). (Binding screw 4x8 (2 pcs for each))
17. Remove the wire harness from the wire saddle.
Elevator spring (F)
Lower safety switch spring
(Front)
[ 4-18 ]
Elevator spring (R)
Lower safety switch spring
(Rear)
Elevator guide (front)
Elevator support plate
Lower limit frame holder
Lower limit frame
ComColor Series (Revision 2.4)