Riso ComColor X1 series Technical Manual page 192

Paper Ejection Section
< FD (Face-Down) Paper Ejection Unit >
1. Turn OFF the machine power and disconnect the power cable from the power source.
2. Remove the left top cover. (Refer to Chapter 2.)
3. Remove the FD paper receiving tray unit.
4. Remove the FD Fence unit.
5. Unplug the wire connector for the FD paper ejection unit. (connector on the machine frame.) - Ref: photo above.
6. Remove the end wall. (Binding screw 4x8 (2 pcs))
7. Remove the access lever D1. (Pan-head screw 3x6 (1 pc))
8. Remove the paper ejection unit. (Round tip IT3C screw 4x8 (2 pcs))
Wire connector for FD paper ejection unit
End wall
Access lever D1
FD Paper Ejection Unit
[ 9-12 ]
ComColor Series (Revision 2.4)