Disassembly; Fb Unit - Riso ComColor X1 series Technical Manual

Disassembly

1. FB unit

1-1. Covers
Turn OFF the scanner power, disconnect the power cable from the power source and remove the covers listed
below.
(1) Left cover
• Remove 4 screws (Binding screw 3x6 (2 pcs), Binding screw 4x6 (2 pcs)), and slide the Left cover to the left to
remove.
(2) Right cover
• Remove 2 shoulder-screws to detach the stage glass support on the right.
• Remove 2 screws (Binding screw 4x6 (2 pcs)), lifting the top edge of the Right cover a little bit, and slide the
cover off to the right.
(3) Front cover
• Remove the Left and Right covers first.
• Remove 4 screws to detach the Front cover (Shoulder-screw (2 pcs), Binding screw 3x6 (2 pcs)).
(4) Rear cover
• Remove the AF unit (Binding screw 4x8 (2 pcs)) and the 2 large shoulder-screws used in mounting the AF unit.
• Remove the Left and Right covers first.
• Remove 6 screws (Shoulder screw (2 pcs), Binding screw 4x8 (2 pcs), Binding screw 3x6 (2 pcs)), push the
stage cover sensor actuator down, and then slide the Rear cover off.
Left cover
Actuator of the stage cover sensor
Shoulder-screw for AF unit mounting
[ 20-13 ]
HS5000 Scanner option
Rear cover
Right cover
Stage glass support
Front cover
x1 Series ComColor (Revision 0.9)