Removing The Head Holder Cover - Riso ComColor X1 series Technical Manual

2-7. Removing the Head Holder Cover

The procedure for removing the head holder cover is as follows. This procedure applies during disassembly and
assembly of all sections in the head unit.
1. Turn OFF the machine power and disconnect the power cable from the power source.
2. Open the front cover and confirm that the maintenance unit is under the head holder (under the print heads). If it
is not, move it to the position under the head holder.
3. Remove the left and right top covers. (Refer to the section on covers in Chapter 2.)
4. Remove the operation panel (the entire bracket; round tip IT3C screw 4x8 (3 pcs)) and rest it on the left side of
the ink cartridge unit.
5. Remove the center inner cover. (Refer to the section on covers in Chapter 2.)
[ 11A-31 ]
Ink Flow Section
Center inner cover
ComColor Series (Revision 2.4)