Riso ComColor X1 series Technical Manual page 801

HS5000 Scanner (option)
(15) Detach the FFC Holder. (The FFC Holder and FFC are in one assembly.)
● Mounting back the Scanner module.
(1) Connect the two FFC onto the CCD PCB. The Ferrite cores should be positioned as shown on the photograph
below.
(2) Align the large ferrite core along the guide underneath.
(3) Set the small ferrite core in the center of the hole on the FFC Holder. Apply 200mg of grease on the Slider on
the FFC Holder.
Large ferrite core
Small ferrite core
(4) Apply 200mg of grease on the Slider on the FFC Holder.
Slider
FFC Holder
Scanner module
[ 20-22 ]
x1 series ComColor (Revision 0.9)