Riso ComColor X1 series Technical Manual page 478

Type U88: PB motor lock error
An error has occurred in the perfect binder.
Display Press the reset key or Reboot by press the Sub Power Key
If recovery fails, contact a service provider.
Clear
Press the Reset key, or turn OFF the printer. (Turn OFF the printer through sub power key.)
Point Description
[Possible cause:
• Motor does not rotate after specifi ed time when motor starts up.
3539 1-2
• Motor not stop rotating when motor received stop request.
• Motor not stop rotating after specifi ed time when sensor detection.]
Variation Code: 1:PB Paper Feed Motor 1, 2:PB Paper Feed Motor 2
PB Cover Cutter Motor malfunction.
3540
Could not detect the PB Cover Cut HP Sensor while running the motor.
3541
PB Vertical Guide Motor malfunction. [Possible cause: Same as 3539]
3542
PB Fore Edge Motor malfunction. [Possible cause: Same as 3539]
Motor malfunction. [Possible cause: Same as 3539]
3543 1-3
Variation Code: 1:PB Clamp Upper/Lower Motor, 2:PB Clamp Open/Close Motor, 3:PB Clamp Horizontal Motor
3544 PB Glue Roller Motor malfunction. [Possible cause: Same as 3539]
3545
PB Glue Sheet Feed Motor malfunction. [Possible cause: Same as 3539]
3546
PB Glue Sheet Unit Drive Motor malfunction. [Possible cause: Same as 3539]
3547
PB Cover Guide Motor malfunction. [Possible cause: Same as 3539]
3548 PB Forming Plate Motor malfunction. [Possible cause: Same as 3539]
Motor malfunction. [Possible cause: Same as 3539]
3549 1-2
Variation Code: 1:PB Booklet Exit 1 Motor, 2:PB Booklet Exit 2 Motor
3550
PB Fore Edge Plate Motor malfunction. [Possible cause: Same as 3539]
3551
PB Blind Plate Open/Close Motor malfunction. [Possible cause: Same as 3539]
3552 PB Cover Feed Motor malfunction. [Possible cause: Same as 3539]
3553
PB Cover Tray Lift Up Motor malfunction. [Possible cause: Same as 3539]
3564
Motor malfunction. [Possible cause: Same as 3539]
Type U89: PB temperature error
An error has occurred in the perfect binder.
Display
Press the reset key or Reboot by press the Sub Power Key
If recovery fails, contact a service provider.
Clear
Press the Reset key, or turn OFF the printer. (Turn OFF the printer through sub power key.)
Point Description
1: Exceeds [high limit temperature 1] by the temperature measurement thermistor on the glue roller during
temperature control.
3554 1-3
2: Exceeds [high limit temperature 2] by the temperature measurement thermistor on the glue roller during
temperature control.
3: Glue roller temperature drops 15 degrees from set temperature at normal temperature control.
1: Exceeds [high limit temperature 1] by the temperature measurement thermistor on the glue tank during
temperature control.
3555 1-3 2: Exceeds [high limit temperature 2] by the temperature measurement thermistor on the glue tank during
temperature control.
3: Glue tank temperature drops 15 degrees from set temperature at normal temperature control.
Type U90: Error history clear error
Display No message
Clear
The error message automatically clears away.
Point Description
At the time of machine power ON, HDD data (error table) is checked. If the data is judged to be broken, the
0262
error history for this error will be kept.
[ 15-47 ]
Panel Messages