Switchback Door Interlock Switch (Switchback Unit A); Switchback Sensor (Switchback Unit A) - Riso ComColor X1 series Technical Manual

2-5. Switchback Door Interlock Switch (Switchback Unit A)

1. Turn OFF the machine power and disconnect the power cable from the power source.
2. Remove Switchback unit A.
3. Remove the Switchback door interlock switch assembly. (Pan-head screw 3x14 (2 pcs))
Note: After the replacement, check the operation by test mode 1190 (switchback door interlock switch).

2-6. Switchback Sensor (Switchback Unit A)

1. Turn OFF the machine power and disconnect the power cable from the power source.
2. Remove Switchback unit A.
3. Remove the switchback sensor mounting plate. (Round tip IT3C screw 3x6 (2 pcs))
4. Remove the switchback sensor. (Pan-head screw 3x14 (1 pc))
Note: After the replacement, check the operation by test mode 1108 (switchback sensor).
(Refer to the instructions in this Chapter.)
(Refer to the instructions in this Chapter.)
[ 10-11 ]
Switchback Section
Interlock switch
Switchback sensor
ComColor Series (Revision 2.4)