Riso ComColor X1 series Technical Manual page 904

Hide thumbs Also See for ComColor X1 series:

Table of Contents

1-3. Staple position adjustment in lateral direction.

> Make this adjustment after completing the Fold Skew Adjustment.

> The two Stapler mechanisms in the Booklet section are mechanically in fixed in position, and perform stapling

operations after paper sheets for one booklet are aligned and centered. This adjustment is performed by

changing the parameters by Test Mode, and the adjustment itself is to adjust the lateral centering of the papers.

< One adjustment applies to all paper sizes. Therefore, individual adjustments for different paper sizes is not

(1) Perform printing or print test pattern to check for staple position deviations in the lateral direction.

< Measure dimension X indicated in the following diagram.>

(2) If there is a staple position deviation, adjust the parameters using Test Mode.

• Enter the parameter shown in the table below using Test Mode No. 4879 [Booklet Tamper Shift Adjustment].

• To reduce dimension X, reduce the parameter number.

Multipurpose

< as Reference>

Test Mode No.

< Refer to the chart below.>

Booklet Tamper Shift

Multifunction Finisher II (option)

depends on the paper size use in adjustment.

Letter-Cover SEF

A4R-Cover SEF

Custom A4 SEF

8.5 x 13 SEF

8.5 x 14 SEF

8-kai (TFX) SEF

8-kai (GCO) SEF

program default setting is in

Increasing the Test Mode parameter number

will slide the staple position to the FRONT.

< Reduces the X value on the above sketch.>

Setting range:

0 to 50 pulses (1 pulse = 0.2618 mm)

x1 Series ComColor (Revision 0.9)

Dimension (mm)

Chapters

Table of Contents