Riso ComColor X1 series Technical Manual page 900

1-2. Staple position adjustment against the fold position, and the Fold position adjustment.
> Make this adjustment after completing the Fold Skew Adjustment described on the previous page.
> This adjustment is done by the Test Mode setting. Adjustments are made separately for the various
parameters (with/without staples, paper size, and number of sheets per booklet).
< Without staples >
(1) Perform printing or print test pattern to check fold position deviations. (Dimension A and dimension B in the
diagram must be equal.)
TOP
(2) If the dimension A does not equal to B, Fold Position Adjustment must be made.
• The adjustment is made by changing the parameters by the Test Modes.
>There are 4 different Test Mode adjustments, depending on the paper size and quantity of sheets per fold, as
given below in the chart of the Test Modes.
• In the case of A > B, reduce the Test Mode parameter setting. In the case of A < B, increase the Test Mode
parameter setting.
Value of <1> changes the folding position 0.1 mm → the difference between A and B would then be 0.2 mm.
ComColor
HC Finisher
Multipurpose
< as Reference>
Finisher
Test Mode No. Test Mode No.
4752 763-232
4753 763-233
4773 763-253
4774 763-254
BOTTOM
FRONT
Item
Fold Position Adjustment in
2-fold (B4 paper or Larger).
Fold Position Adjustment in
2-fold (Smaller than B4 paper).
Fold Position Adjustment for
Two-sheet Folding for Booklet
Production (without staples).
Fold Position Adjustment for
Three or More-sheet Folding
for Booklet Production (without
staples).
REAR
Eject direction
Type
D
D
D
D
[ 24-85 ]
Multifunction Finisher II (option)
Description
(
program default setting is in
Setting range:
0 to 200 pulses (1 pulse = 0.1 mm)
< 100 >
Setting range:
0 to 200 pulses (1 pulse = 0.1 mm)
< 100 >
Setting range:
0 to 200 pulses (1 pulse = 0.1 mm)
< 100 >
Setting range:
0 to 200 pulses (1 pulse = 0.1 mm)
< 100 >
x1 Series ComColor (Revision 0.9)
)
< >