Fd Paper Ejection Full Detection Sensor; Fd Paper Ejection Motor (Fd Paper Ejection Unit); Fd Paper Ejection Motor Fg Sensor (Fd Paper Ejection Unit) - Riso ComColor X1 series Technical Manual

Paper Ejection Section Paper Ejection Section
2-4. FD Paper Ejection Full Detection Sensor (FD Paper Ejection Unit)
1. Turn OFF the machine power and disconnect the power cable from the power source.
2. Remove the FD paper ejection unit. (Refer to the instructions for removal.)
3. Unplug the sensor wire connector.
4. Remove the sensor together with the mounting bracket. (Round tip IT3C screw 3x6 (1 pc))
5. Detach the sensor from the bracket.
Note: After the replacement, check the operation by test mode 1151 (paper receiving FULL sensor).

FD paper ejection full detection sensor

2-5. FD Paper Ejection Motor (FD Paper Ejection Unit)

1. Turn OFF the machine power and disconnect the power cable from the power source.
2. Remove the FD paper ejection unit. (Refer to the instructions for removal.)
3. Remove the FD paper ejection motor. (Pan head screw 3x5 (2 pcs))
Note: After the replacement, check the operation by test mode 1300 (paper ejection motor).
FD Paper ejection motor FG sensor

2-6. FD Paper Ejection Motor FG Sensor (FD Paper Ejection Unit)

1. Turn OFF the machine power and disconnect the power cable from the power source.
2. Remove the paper ejection motor by the procedure given above.
3. Unhook the FD paper ejection motor FG sensor from its bracket.
Note: After the replacement, check the operation by test mode 1150 (FD paper ejection motor FG sensor).
Paper ejection motor
[ 9-14 ]
SCREW
ComColor Series (Revision 2.4)