Riso ComColor X1 series Technical Manual page 496

Type W62: Press Start key
Display
Turn off the power of this printer and then on again.
Press the Start button.
Clear
Note: When the printer is automatically deactivated after completion of downloading, it cannot be restarted
automatically, so press the Power button to start it.
Point Description
Because writing the Auto Power On fl ag failed when downloading fi rmware other than fi rmware for the panel,
0078
the printer could not start up automatically.
Note: The fi rmware was downloaded successfully.
Type W63: Supply main power again
Display
Turn the power SW OFF then ON
Press the Close button.
Clear
Then re-boot the machine.
Point Description
After downloading the Panel fi rmware, when main switch of the machine is switched ON later, the machine
0079 boots up without pressing the power switch on the operation panel.
Note: The fi rmware was downloaded successfully.
Type W64: HDD initialization error
Display No message
Clear
Press the Close button.
Point Description
0242 During the system rebooting, HDD cannot initialize.
Type W66 : External CI connection error
Display
Save to archive in Ex.CI cannot be performed.
Clear
Press the Close button.
Point Description
When archive store is selected without external CI connected, the archive, even though not stored, error
0243
message is not displayed.
Type W67: Remote Agent communication error
Display Transmission error to the Control server. Call Service
Clear
Press the Close button.
Point Description
Communication error with the Remote Agent server.
1-<Network not connected (no ping).>
0244 1-4
2-<Able to communicate with the Remote Agent server, but time-out error occurs.>
3-<Unable to connect with the Proxy server.>
4-<Unable to log-on to the Proxy server.>
Type W68: BP Belt stain detected
Display
The image may not be printed in properly caused by the soiled transfer path. Call serivice.
Press <Continue> or <Cancel> button.
Clear
Delete the print job.
Point Description
0245 Belt stain is detected by CIS when printing started.
Type W69: Paper Feed Tray not ready
Display Ready to resume. Press the [Confi rm] button.
Clear
Press <Confi rm> button.
Point Description
1935 Paper feed tray not ready to use
[ 15-65 ]
Panel Messages