Riso ComColor X1 series Technical Manual page 886

1-3. Stapling and folding operations
• The End Guide lifts to the staple position to perform stapling.
Stapling is performed at a position below the fold position.
• The End Guide lifts the paper to the fold position.
• The Knife moves, and the Booklet Pre-Folding Roll and Booklet Folding Roll fold papers in sequence while the
set of paper is transported.
The Knife extension and retraction movement is performed by one full rotation of the gear, which is engaged
when the Knife Solenoid activates.
To confirm proper operation of the Knife, the extended position of the Knife is detected by the Knife Folding
Sensor, and the retracted position is detected by the Knife Home Sensor.
• Then, the set of paper is discharged toward the Booklet Tray by the Booklet Eject Roll.
• The paper transport status is detected by the Booklet IN Sensor, Booklet Compile NO Paper Sensor, Booklet
Folder Roll Exit Sensor, and Booklet Tray NO Paper Sensor, all of which are located along the paper path.
> Although a single folding operation is performed in the default setting, you can adjust the number of folding
operations using Test Mode No. 4776 "FOLDING TIME".
Note that increasing the number of folding operations can improve folding results, but slows down the
processing speed.
> The maximum number of paper sheets processed by the Booklet section is 15 sheets if the paper is stapled
and 5 sheets if the paper is not stapled. You can change these limit settings using Test Mode No. 4771
"Max Booklet Stapling" and Test Mode No. 4772 "Max Booklet Non-stapling".
Note that increasing the maximum number of sheets can result in lower quality folding precision, reduced
staple strength, or stapling failures.
[ 24-71 ]
Multifunction Finisher II (option)
x1 Series ComColor (Revision 0.9)